The Sunco Duct 1ZANT-40-5X25 is a CNC-manufactured insulated distribution box with one 400mm motorised inlet supplying five 250mm outlets as a single zone.
IIts precision-mitred body is manufactured from 21mm foil-faced PIR ductboard, delivering a calculated material rating of R0.95.
Comparable EPP products generally require approximately 40mm thickness to approach R1.0- worth checking when assessing R-value claims on thin moulded boxes. Foamed rotomoulded LLDPE fittings may require approximately 25–35mm to reach R0.4, depending on foam density, consistency and verified thermal conductivity.
While R0.4 may satisfy minimum requirements in some applications, higher thermal resistance provides greater protection against surface condensation in Queensland’s hot, humid roof spaces—helping prevent coffee-coloured ceiling stains and costly callbacks.
Pair it with our Australian made 4-Zero R1.5 Flexible Duct for a high-performance thermal installation designed for Queensland conditions.
Custom spigot and motorised zone-outlet configurations are available in 200mm, 250mm and 300mm sizes. Hit us up and we can make it happen!
Fast Clip-In Installation
The ANT body fits through most larger return-air grille openings before its fittings are installed.
Each 250mm outlet spigot fits through the opening for a 250mm round diffuser. Tape the flexible duct to the spigot below the ceiling, pass it into the roof space and clip it directly into the ANT body.
Features
Five 250mm outlets controlled as one zone
1 × 400mm clip-in zone motor
5 × 250mm clip-in outlet spigots
400mm zone-motor cable included
Graphene foam seal on every clip-in connection
CNC-cut, precision-mitred PIR construction
Fittings install after the body is positioned
Less taping and assembly in confined roof spaces
Specifications
| Specification | Details |
|---|
| Product Code | 1ZANT-40-5X25 |
| Configuration | One zone supplying five outlets |
| Body | 21mm foil-faced PIR ductboard |
| Body Size | 550 H × 600 W × 420 D mm |
| Thermal Conductivity | 0.022 W/m·K |
| Calculated Material R-Value | R0.95 m²·K/W |
| Inlet | 1 × 400mm clip-in zone motor |
| Outlets | 5 × 250mm clip-in spigots |
| Typical Airflow* | 450–600 L/s |
| Typical Balanced Outlet Airflow* | 90–120 L/s each |
| Maximum Recommended Airflow | 1,000 L/s total |
| Maximum Balanced Outlet Airflow | 200 L/s each |
| Zone-Motor Cable | Included |
| Connection Seals | Graphene foam |
1Z = one controlled zone · ANT = insulated box body · 40 = 400mm inlet · 5X25 = five 250mm outlets
*Indicative airflow assumes two balanced ANT boxes connected to separate supply-air paths, each using up to 6m of fully extended 400mm flexible duct. Outlet figures assume all five outlets are open and connected through up to 6m of fully extended 250mm flexible duct.
Actual airflow depends on fan capacity, available static pressure, duct compression, bends, terminal resistance, balancing and commissioning. Thermal figures are calculated material values; finished thermal performance depends on verified material properties, sealing and installation.
